Ice Chute Cleaning (Weekly Or Daily Cleaning Also); Dis-Assemble Ice Chute; Clean Ice Chute; Sanitize Ice Chute - Cornelius ABS 2.0 Operator's Manual

ICE CHUTE CLEANING (WEEKLY OR DAILY CLEANING ALSO)

The ice chute needs to be cleaned monthly to remove mold/mildew buildup.
NOTE: The ice chute has a built-in safety feature. When the ice chute cover is removed, the unit is
disabled. If the ice Chute cover is not properly installed, then ice chute gate will not
operate.

Dis-assemble Ice Chute

1. Hold ice chute cover and push up until you hear
a click and side latches are disengaged as
shown in Figure Figure 54.
2. Lift off the ice chute cover and set it aside as
shown in Figure Figure 55.

Clean Ice Chute

1. Clean the interior of the ice chute and cover with a long handled nylon bristle brush. Use soap solution and
warm water mixture, rinse with clean potable water, and allow to air dry.
NOTE: Do not place ice chute or cover in the dishwasher.

Sanitize Ice Chute

1. Spray the ice chute and cover inside and out with Sanitizing Solution and allow it to air dry.

Re-assemble Ice Chute

1. Carefully insert ice chute cover and slide down to
fully engage. Make sure cover side latches mate
flush with ice chute base before sliding down as
shown in Figure Figure 56.
© 2019, Cornelius Inc.
Figure 54.
Figure 55.
Figure 56.
- 29 -
ABS 2.0 Operator's Manual
Publication Number: 621058590OPR