ABS 2.0 Operator's Manual
Beverage Dispensed
The P.O.S sends the drink portion of the order to the ABS 2.0 where the information is interpreted and the drink is
dispensed.
If the drink requires a top-off, the initial portion will be dispensed. After a delay, the balance of the drink will be
dispensed.
Cup Is Moved To Cup Serve Point
Sensors check for a cup in position "A." If the sensor is clear, the conveyor moves the cup to cup serve position
"F."
The display will indicate the Brand & Ice portion of the beverage along with the order #
at cup serve position "F."
Crew Member Serves Drink
A crew member caps the drink while still on the conveyor and serves it with the remainder of the order.
S
O
(U
A
)
EMIAUTOMATIC
PERATION
NIT IN
UTOMATIC
Press Cup Size
Operation of the ABS 2.0 is restricted to employees and service personal that have been trained and certified in
the proper operation, service and maintenance of the equipment.
While in automatic mode, to dispense a drink semi-automatically, press the desired cup size button.
Press Special Ice Requirement If Requested
If extra ice is desired, press the EXTRA ICE button. If no ice is required, press the NO ICE button. If light ice is
desired, press the LIGHT ICE button. If only ice is desired, press the ONLY ICE button.If normal ice is desired, no
button is pressed. As shown in Figure Figure 10.
Figure 10.
When Correct, Press Enter
Sequence of pressing the cup size, brand, and special ice buttons is not important. At any time, pressing any
button will change the selection of the drink to be dispensed. When the correct order is displayed, press ENTER
and the drink will be dispensed.
Any Drink through Semi automatic method, OR under quotes are identified by the order ID saying "ABS" instead
of a number.
© 2019, Cornelius Inc.
- 11 -
Publication Number: 621058590OPR