Page 1
Cornelius IDC PRO Cleaning Instructions & Trouble Shooting...
Page 2
NOZZLES AND DIFFUSERS - DAILY CLEANING Remove the nozzles from the dispenser by turning each nozzle to the left and pulling down. Remove the inner diffusers by pulling down; separate the clear gasket from the diffuser. Note orientation of gasket for reinstallation (shown on page 4)
Page 3
NOZZLES AND DIFFUSERS - DAILY CLEANING Clean the diffusers, nozzles and gaskets thoroughly with the nylon bristle brush and soapy water. Rinse them with water. Put the nozzles, gaskets and the diffusers in sanitizer solution for minute. Don’t over soak or they will dry out.
Page 4
NOZZLES AND DIFFUSERS – DAILY CLEANING Install the gasket into the diffuser. Line up the two notches on the inner circle of both the gasket and diffuser. Push the silicone gasket into the diffuser. Make sure that the raised side of the clear gasket is face-up when re- inserting the diffuser.
Page 5
NOZZLES AND DIFFUSERS - DAILY CLEANING Brush the diffuser area under the machine thoroughly with a nylon bristled brush. Wipe under side of valves with sanitizer cloth. Allow to air dry.
Page 6
NOZZLES AND DIFFUSERS – DAILY CLEANING Re-install the inner Diffuser and Gasket into nozzle base by rotating slightly while pushing up. Re-install outer nozzle and twist to lock in place NOTE: Ensure the outer nozzle is on STRAIGHT when locking.
Page 7
CLEANING ICE CHUTE Clean the interior of the ice chute using the brush provided with the unit. Use warm soapy water, rinse with clear (not soapy), water using brush, then do a final rinse using the brush with sanitizer water. ...
Page 8
CLEANING THE SCREEN, MACHINE & DRAIN Clean the screen using a sanitized towel, then wipe face with dry towel. Refer to page 11 on how to lock screen during cleaning. Clean the remainder of the machine using a sanitized towel.
Page 9
ACCESSING THE MENU’S Display the keypad screen by tapping each corner of the video screen starting in the upper right corner continuing to tap each corner in a counter clockwise direction, in the form of a “C”. This will display the Key pad screen. ...
Page 10
SCREEN CLEANING LOCKOUT Select Screen Cleaning Lockout Screen Cleaning 20sec Lockout Screen The screen cleaning lockout screen allows you to clean the digital merchandiser without dispensing product. Touch inside the circle to activate the 20 second lockout.
Page 11
SOLD OUT SYRUP The “Sold Out” application allows you to place a “Sold Out” logo over the brand that is sold out. Be sure to hit “Save” before exiting. To unmark, hit the brand again and hit “Save” before exiting.
TROUBLE SHOOTING If the screen freezes up – press the red reset button. If nothing happens, hold that button in for 5 seconds until the screen goes black, wait 10 seconds and press button again to restart. If the machine does not have a red reset button, gently disconnect the gray connectors and then reconnect them together.