Prepare To Rinse Hopper; Rinse Hopper; Prepare To Sanitize Hopper - Cornelius ABS 2.0 Operator's Manual

Prepare to Rinse Hopper

1. Put strainer hose in bucket of clean potable water.
Make sure it reaches the bottom as shown in Figure
Figure 48.
2. Open manual ice fill door and put the spray hose
inside the hopper. Make sure the valve is closed
(handle perpendicular to valve) as shown in Figure
Figure 49.

Rinse Hopper

1. When ready press *START CIP PUMP* button, open spray valve with a 90° turn and begin spraying all
around hopper and hard to reach corners. Spray until bucket is empty. Avoid spraying directly into bottom of
ice maker. Try to spray both sides of agitator.
2. When finished press *STOP CIP PUMP* button and close valve with a 90° clockwise turn. To avoid exces-
sive wear to CIP pump, turn off immediately after bucket is empty.

Prepare to Sanitize Hopper

1. Put strainer hose in bucket of Sanitizing Solution.
Make sure it reaches the bottom as shown in Figure
Figure 50.
© 2019, Cornelius Inc. - 27 -
ABS 2.0 Operator's Manual
Figure 48.
Figure 49.
Figure 50.
Publication Number: 621058590OPR