Re-Assemble Staging - Cornelius ABS 2.0 Operator's Manual

ABS 2.0 Operator's Manual

Re-assemble Staging

1. The cup rest must be installed with the oval rails
up and the "Cup Positioning Bracket" must be at
the rear of the drip tray as shown in Figure Fig-
ure 20.
NOTE: The cup positioning bracket,
located on the cup rest, contains
a spring that is positioned so it
touches the cup in the cup
holder as the cup moves past the
spring. This moves the cup to the
rear (based on the direction of
movement) of the cup holder.
This ensures that all cups will be
in the same position regardless
of its size.
2. Align the drive pin on the left side of the conveyor
assembly so that the conveyor seats properly as
shown in Figure 19. The conveyor drive pin must
engage the drive socket on the gear box as
shown in Figure Figure 21.
NOTE: When installing the conveyor, it
may be necessary to move the
conveyor manually to allow the
drive pin to insert into the drive
socket
3. Re-install the cover and then tighten the thumb
screws on the cover as shown in Figure Figure
22.
Publication Number: 621058590OPR
Figure 20.
Figure 21.
Figure 22.
- 16 - © 2019, Cornelius Inc.