Prepare To Clean Hopper; Clean Hopper - Cornelius ABS 2.0 Operator's Manual

ABS 2.0 Operator's Manual
2. Locate the CIP access door on the lower right hand
side of the unit and pull the 2 CIP hoses out as
shown in Figure Figure 45.

Prepare to Clean Hopper

1. Put strainer hose in bucket of soap solution. Make
sure it reaches the bottom as shown in Figure Fig-
ure 46.
2. Open manual ice fill door and put the spray hose
inside the hopper. Make sure the valve is closed
(handle perpendicular to valve) as shown in Figure
Figure 47.

Clean Hopper

1. When ready press *START CIP PUMP* button, open spray valve with a 90° turn and begin spraying all
around hopper and hard to reach corners. Spray until bucket is empty. Avoid spraying directly into bottom of
ice maker. Try to spray both sides of agitator.
2. When finished press *STOP CIP PUMP* button and close valve with a 90° clockwise turn. To avoid exces-
sive wear to CIP pump, turn off immediately after bucket is empty.
Publication Number: 621058590OPR
Figure 45.
Figure 46.
Figure 47.
- 26 - © 2019, Cornelius Inc.