Re-Assemble Nozzle - Cornelius ABS 2.0 Operator's Manual

ABS 2.0 Operator's Manual

Re-assemble Nozzle

1. Re-install the diffuser gasket in the diffuser by
aligning the key-slot of the diffuser gasket and
the diffuser as shown in Figure Figure 31.
NOTE: Ensure gasket is seated properly
and the correct side is facing
upwards.
2. Reinstall the diffuser by pushing it vertically
upward by aligning the key-slot as shown in Fig-
ure Figure 32.
NOTE: Make sure the nozzle is
assembled and it is vertically
aligned or both the locking tabs
are properly engaged in slot.
3. Re-install the nozzle in the unit by rotating it in
clockwise direction as shown in the Figure Figure
33.
NOTE: Make sure the tabs are aligned
properly before rotating in order
to avoid cross threading.
Publication Number: 621058590OPR
Figure 31.
Figure 32.
Figure 33.
- 20 - © 2019, Cornelius Inc.