Sanitize Hopper; Post-Cleaning Phase - Cornelius ABS 2.0 Operator's Manual

ABS 2.0 Operator's Manual
2. Open manual ice fill door and put the spray hose
inside the hopper. Make sure the valve is closed
(handle perpendicular to valve) as shown in Figure
Figure 51.

Sanitize Hopper

1. When ready press *START CIP PUMP* button, open spray valve with a 90° turn and begin spraying all
around hopper and hard to reach corners. Spray until bucket is empty. Avoid spraying directly into bottom of
ice maker. Try to spray both sides of agitator.
2. When finished press *STOP CIP PUMP* button and close valve with a 90° clockwise turn. To avoid exces-
sive wear to CIP pump, turn off immediately after bucket is empty.

Post-cleaning Phase

1. Drain both CIP hoses and return back to unit as
shown in Figure Figure 52.
2. Make sure manual fill door is closed.
3. Turn on the ice maker by either locating the power
button behind the ice maker's front panel or navigat-
ing through the ice maker menu screen. Refer to ice
maker manual. Ice maker takes a while to start
making ice again, use this time to complete the ice
chute cleaning as shown in Figure Figure 53.
Publication Number: 621058590OPR
Figure 51.
Figure 52.
Figure 53.
- 28 - © 2019, Cornelius Inc.