Replacing The Upper Knife - ELNA eXtend 864air Manual

z x c
q
w
z x c v b
q
t
r
Zamena gornjeg noža

Replacing the Upper Knife

Make sure to turn the power switch off before
Obavezno isključite glavni prekidač pre zamene
replacing the upper knife.
gornjeg noža.
To remove:
Uklanjanje:
z Open the looper cover.
Otvorite poklopac petljača.
e
x Turn the handwheel toward you until the upper knife
Okrećite zamajac ka sebi sve dok gornji nož ne dosegne
reaches its highest position. najviši položaj.
c Remove the hexagonal bolt with the double-ended
Uklonite šestougaoni vijak ključem sa dva kraja
spanner (use the small end) and remove the upper
(koristite manji kraj) i uklonite gornji nož.
knife.
q Upper knife
w Hexagonal bolt
e Double-ended spanner (small end 5.5 mm)
To attach:
Postavljanje:
z Attach the new upper knife to the upper knife
Postavite novi gornji nož na nosač gornjeg noža i
supporter and partially tighten the hexagonal bolt.
delimično ga pričvrstite šestougaonim vijkom.
q Upper knife
w Hexagonal bolt
r Upper knife supporter
y
x Turn the handwheel toward you until the upper knife
Okrenite zamajac ka sebi sve dok gornji nož dosegne
reaches its lowest position.
svoj najniži položaj.
c Loosen the hexagonal bolt.
Olabavite šestougaoni vijak.
Adjust the position of the upper knife so that its blade
Podesite položaj gornjeg noža tako da se preklapa 1.0
overlaps 1.0 mm to 1.2 mm (3/64˝) with the edge
do 1.2 mm sa donjim nožem kao što je prikazano na
of the lower knife as shown, and fully tighten the
slici levo, a zatim zategnite potpuno šestougaoni vijak.
hexagonal bolt.
t Lower knife
y 1.0 – 1.2 mm (3/64˝)
w
v Turn the handwheel toward you several times to check
Okrenite zamajac ka sebi nekoliko puta kako biste
the blade position.
proverili položaj gornjeg noža.
b Close the looper cover.
Zatvorite poklopac petljača.
54
PAŽNJA
Gornji nož
Šestougaoni vijak
Ključ sa dva kraja (manji kraj 5.5 mm)
Gornji nož
Šestougaoni vijak
Nosač gornjeg noža
Donji nož
1.0 - 1.2 mm