Table of Contents
Advertisement
Process Control Results
ID sensor test: SP 3-325
000 = Front, Center, Rear
e.g. 111
Process Control Self-Check Result: SP3-012
YY
CC
e.g. 11
Line Position Adjustment Result: 2-194-10~12
Slide 361
Each of these SPs gives a result code.
For the meanings of each code, and how to proceed, see the above section of
the service manual.
This section gives more details on how to solve problems that occur with line
position adjustment.
Some steps ask you to use SPs. See the SP tables for details on each SP.
Some of the SP adjustment have 'dot' and 'subdot' settings. These let you adjust
the position of the lines. Adjust the 'dot' setting first, for a rough adjustment.
Then, adjust the 'subdot' setting for a fine adjustment.
Successfully completed
MM
KK:
11
11
11
Successfully completed
Service manual, Troubleshooting, Process Control Error
Service manual, Troubleshooting, Troubleshooting Guide
361
11
~
99
99
99
99
Di-C1.5 Training
Conditions
Advertisement
Table of Contents
