Ricoh Di-C1.5a Manual page 212

Replacement – Image Transfer Unit (1)
Image Transfer Belt Unit
The ITB is in contact with the K drum before you
turn the switch off. Take care not to damage the K
drum.
» To release the ITB from the K drum, you must turn the
image transfer belt unit lock lever clockwise before you
remove the unit. If you do not do this, you will damage
the K drum.
If the power fails in the middle of a color job with
the ITB in contact with all four drums, you cannot
remove the ITB.
» Remove the exit tray, then turn the gear until the belt is
fully raised. After that, the ITB contacts the K drum only.
Remove the ITB unit motor from the old ITB unit
and install it in the new one. The new ITB unit
does not have an ITB unit motor.
Slide 212
No additional notes
212
Di-C1.5 Training