Ricoh Di-C1.5a Manual page 171

At the end of a job:
Done if 250 b/w or 100 full color prints were made since the
previous adjustment (SP 3515 001/002).
During a job:
Done if 500 b/w or 200 full color prints were made since the
previous adjustment (SP 3515 003/004).
» The machine checks the above condition every 5 pages (SP
3512 001). Then, potential control is done if the condition
occurs.
Done every 20 pages (A4) or every 10 pages (A3) if the
following two conditions both occur:
» Temperature is higher than 30 °C (SP 3-520-010) or lower
than 15 °C (SP 3-520-011)
» Pixel coverage is more than 20% for any one color (SP 3-224-
017 [high temperature]/018 [low temperature])
Done every 10 pages (A4) or every 5 pages (A3) if the
following two conditions both occur:
» 60 mm/s mode (1200 dpi, OHP/Thick Paper)
» Pixel coverage is more than 10% for any one color (SP 3-224-
022)
Slide 171
During a job: This process control is longer than other process controls; it takes
40 seconds
At 14 pages, a flag is set. This flag is checked every 5 pages. Then, if a
condition occurs that requires process control, and the flag happens to be
set, process control is done.
If the flag is checked every 5 pages, why is the first check at 20 pages
and not 15 pages? The machine does not have time to prepare for
process control between page 14 and page 15. So process control is
done at the next 5-page interval (page 20).
AT-C1: The flag is checked every 30 sheets.
You cannot adjust the intervals with SP 3515 001 to 004. These SPs only show
the current settings. To change the current settings, you must adjust SP 3511
001 to 004 (base value) and SP 3511 022 to 029 (coefficients)
When is it Done? (2)
171
Di-C1.5 Training