HP 8712C User Manual page 40

Getting Started
Entering Measurement Parameters
Presetting the Analyzer
Press the (FEEEQ key. When the analyzer is preset with the @SiZi] key,
it reverts to a known operating condition. When this key is pressed, the
following major default conditions apply:
2-6
Frequency rangel
Frequency range*
Power level3
Measurement Channel 1
measurement
Measurement Channel 2
measurement
Format
Number of points
Sweep time
Scale
Reference
System Bandwidth
1
HP 87121: only
2
HP 8714C only
3 Preset power level can be set to other then 0 dBm if desired. See 'Entering
Source Power Level,' later in this chapter for more information.
N O T E
The measurement parameters that you enter will be retained in the analyzer's memory when the
power is turned off, and will be restored when the power is turned back on.
See Also
Refer to Chapter 12, "Preset State and Memory Allocation," for a comprehensive table of preset
conditions.
0 . 3 t o 1 3 0 0 M H z
to 3000 MHz
0.3
0 dBm
Transmission
Off
201
Auto
1 0 dB/div
0 dB
Medium Wide