Table of Contents
Advertisement
Printing on Fabric Sheets
Canon Fabric Sheet FS-101 comes with a booklet that describes special handling
procedures. Be sure to read this booklet for special information on fabric sheets.
n
• Do not use the fixing agent provided with the Canon Fabric Sheet FS-101. This agent is
not necessary when printing with your unit.
• Do not touch newly printed fabric sheets until the ink has dried completely. This takes
about an hour.
Follow this procedure to load a fabric sheet in the multi-purpose tray:
1
Make sure the paper thickness lever is
e
set to
(right).
• For details, 1 p. 5-6.
c
Do not set the paper thickness lever
while the unit is printing since this
will cause problems.
2
With the cloth side towards you and
the open end at the top, insert one fabric
sheet into the multi-purpose tray q, and
align the right edge of the sheet with the
right side of the multi-purpose tray. Slide
the paper guide snugly against the left
edge of the sheet w.
3
Your unit is now ready to print. Set your
PC to print on the fabric sheet.
4
When the fabric sheet is printed, let it dry
for about an hour to allow the ink to dry
completely.
5
When dry, peel the film backing from the
printed fabric sheet.
Chapter 5
C
a
I n
B
r t
k
C
r i
B
l -
d
l a
g
2
e
M
c
1
a
k
J
d
a
e
p
a
in
n
OPEN END AT
THE TOP
2
Paper Handling
1
5-13
Advertisement
Table of Contents
