Table of Contents
Advertisement
5
Press [-] or [+] to set the frame erase width © press [OK].
The selected mode is set, and the display returns to the Special Features screen.
NOTE
•
To enter values in millimeters, press [mm].
•
When entering values in millimeters, you can also use
(Clear) to clear your entries.
•
You can change the values by pressing [-] or [+], even if you have entered the
values using
-
•
If you enter a value outside the setting range, a message prompting you to enter an
appropriate value appears on the screen.
•
The default setting is '3/4" (18 mm)'. The maximum width that you can set for the
Binding Erase mode is '13/16" (20 mm)'.
6
Press [Done] © [OK].
The display returns to the Send Basic Features screen.
7
Press
(Start).
Follow the instructions that appear on the touch panel display © press
once for each original. When scanning is complete, press [Done].
Scanning starts.
The scanned data is sent to the specified destination when scanning is complete.
(numeric keys).
-
(numeric keys), and
(Start)
Frame Erase
4-15
4
Advertisement
Table of Contents
