Table of Contents
Advertisement
6 CONTROLS
6.3
VISUAL DISPLAY _____________________________________________________
The visual display is activated when the ignition is turned on.
6.3.1 STARTUP SCREEN __________________________________________________
When the Ignition Key is turned to the start position, this screen is shown.
The Hour Meter will show total hours of engine operation.
6.3.2 WARNING / SERVICE SCREEN_________________________________________
After the Startup Screen the Warning Screen is
shown, the screen is visible for four seconds. If the
machine is within 5 hours of the next service, a
warning is shown. An operator input is needed to
continue to the Home Screen. If there is no input
needed, the main screen will become visible. If a
fault condition has occurred during the previous
start, a pop up screen will become visible over the
top of the warning screen. The operator must
confirm the fault before they can move to the Home
Screen.
ICONS
1
11
2
12
3
13
4
14
5
15
16
6
7
17
8
18
H
2
O
9
19
10
en-34
1.
Park Brake Engaged
2.
DPF Inhibit
3.
DPF Regeneration Request
4.
DPF Regeneration Ongoing
5.
TST™ Active (Optional
6.
TST™ Not Active (Optional)
7
Cutter Indicator (Flashes if not in off position on start up)
8.
Water In Fuel Warning
9.
Transport Lock
10.
Foot Pedal Warning (Flashes if not in neutral position on start up)
11.
Seat Warning (Flashes if not occupied or disconnected on start up)
12.
Fuel Indicator (Below bar graph)
13.
Engine Temperature Indicator (Below bar graph)
14.
Check Engine
15.
Traction Boost / Weight Transfer
16.
Engine Able To Start (Green)
17.
Engine Unable To Start (Red)
18.
Fan
19
Backlap
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should
read the entire operators manual before
attempting to set up, operate,
adjust or service
the machine.
2.5 Hours
®
1234
123.4 Hours
P
TM
Advertisement
Table of Contents
