Table of Contents
Advertisement
6.4
FAULT LOG _________________________________________________________
The first page within the Fault Log makes it possible to see any Fault
Popup Warnings that have occurred and been cleared, that are however
still active. Button 2 & 3 can be used to scroll through if there is more
than one, Button 1 exits to the Service Menu.
Button 4 takes the screen to the second Fault Log page which displays a
list of the last 100 faults along with the Time, Date and Engine Hours that
the fault occurred.The number in the top right hand corner shows the total
number of faults recorded, and Button 1 can be used to exit to the Ser-
vice Menu.
Note: The fault displayed is an example and the actual popup seen by the operator may be different.
6.4.1 TIME UNTIL SERVICE ________________________________________________
This screen gives the number of engine hours until the next service
inspection is required.
To reset the service interval press & hold Button 2, 3 & 4 until the figure
changes. Note: this should only be done once the required service has
been completed.
6.4.2 VEHICLE DIAGNOSTICS ______________________________________________
These screens give access to various machine parameters. Buttons 2 &
3 can be used to scroll between the pages, Button 1 returns to the
Service Menu.
CONTROLS 6
101010
1/2
Fault Log
= 3
Time
Date
Hours
1
00:44:27
04/01/21
0000.0
2
00:40:32
04/01/21
0000.0
DPF
3
00:31:12
04/01/21
0000.0
SENSOR
Time Until Service
50
Hours
Software Versions
Controller Software Version:
00000000.00.00
HMI Software Version:
00000000.00.00
en-37
Advertisement
Table of Contents
