Table of Contents
Advertisement
5 CONTROLS
5.2.Z.1
VISUAL DISPLAY ________________________________________________
The visual display is activated when the ignition is turned on.
5.2.Z.2
STARTUP SCREEN ______________________________________________
When the ignition key is turned to the start position, this screen is shown.
The hour meter will show total hours of engine operation.
5.2.Z.3
WARNING/SERVICE SCREEN _____________________________________
After the startup screen the warning screen is shown, the screen is visible for
Four seconds. If the machine is within 5 hours of the next service, a warning is shown.
An operator input is needed to continue to the main screen. If there is no input needed,
the main screen will become visible. If a fault condition has occurred during the previous
start,
a pop up screen will become visible over the top of the warning screen. The
operator must confirm the fault before they can move to the main screen.
5.2.Z.4
FIRST SCREEN _________________________________________________
This screen shows the cutter switch in the OFF position, the transport lock engaged,
the TST is in operation and speed mode.
By pressing
the MODE button the transmission mode can be changed between
Automatic, Manual and Creep. Cruise control in enabled by default
The Slope Monitoring System "TST™" (Tilt Sensor Technology) Is A Slope
Angle Warning System Only. It Does Not Increase The Safe Working Slope
Beyond That Of The Declared Safe Slope.
5.2.Z.5
ENGINE START _________________________________________________
When the ignition key is turned to the start position, this screen is shown.
If the parking brake is applied, the cutting unit switch is in the OFF position and the foot
pedal is in the Neutral position. When the operator is in the seat, the engine will start.
This screen shows the fuel bar graph on the left side. The colour changes from green to
red as the fuel level decreases. The engine temperature gauge is on the right side. The
colour changes from green to red as the temperature increases.
en-26
WARNING
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should read
the entire operators manual before attempting
to set up, operate, adjust or service the
machine.
MODE
Advertisement
Table of Contents
