Table of Contents
Advertisement
6 CONTROLS
6.5.5 INCLINOMETER _____________________________________________________
Using the PIN Menu Buttons 2 and 3 to arrow up and down, and
Button 4 to select Inclinometer and this gives you the option to Enable or
Disable TST™.
Note: If TST™ is installed, but disabled via the screen, the machine angle
when greater than 14° will be displayed, however no alarms or physical
interventions will occur.
If TST™ is not installed then Not Installed will be displayed on this
screen and the Disabled and Enabled options will be greyed out.
6.5.6 RESET DEFAULT PARAMETERS _______________________________________
The machine will have factory set
defaults. You can reset to factory
settings by Using the PIN Menu
Buttons 2 and 3 to arrow up and
down, and Button 4 to select Set
Default Parameters. Press arrow to
confirm.
6.5.7 DISPLAY INCLINES __________________________________________________
Only Visible if TST™ is installed and
enabled showing machine angle.
Left/Right, Forward Backwards.
Rotating graphics to illustrate
direction. With a central value
underneath each picture to show
magnitude of angle.
To access this screen go to Main
Menu, Service Menu, Display
Inclines then Button 4.
6.5.8 CHANGE PIN _______________________________________________________
Using the PIN Menu Buttons 2 and 3 to arrow down to the bottom of the
list, and Button 4 to select Change Pin, this gives you the option to
change from the default Owner's PIN Number.
en-46
Set Default Parameters
Press
To Confirm Set
To Default Parameter Values
Display Inclines
0 º
0 º
Inclinometer
Disabled
Enabled
Not Installed
Set Default Parameters
Press
To Confirm Set
To Default Parameter Values
Are You Sure?
Yes
No
Display Inclines
45 º
45 º
Change Pin - Owner
New PIN: * * * *
Confirm: 1 _ _ _
Advertisement
Table of Contents
