H Visual Display; Start Up Screen; Warning/Service Screen - Ransomes Highway 3 Safety, Operation & Maintenance Manual

6 CONTROLS
6.2H VISUAL DISPLAY ________________________________________________
Is activated when the ignition is switched on.
6.2H.1

START UP SCREEN ______________________________________________

Upon initial power up this screen will be shown.
The hour meter will show total engine running hours.
6.2H.2

WARNING/SERVICE SCREEN ______________________________________

After the start up screen the following warning screen will
be applied, it will remain in view for a few seconds, if the
machine is within 5 hours of the next service interval a
warning shall be shown and an operator input required
to continue to the main run screen, otherwise the main
run screen will appear. If a fault condition has occurred
during the previous start up then a pop up screen should
appear over the top of the warning screen, pausing the
warning screen timer, indicating the type of fault. The
operator then has to acknowledge the fault before
continuing to the main screen.
en-28
1234.5
WARNING
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should read
the entire operators manual before attempting
to set up, operate, adjust or service the
machine.
Service required in
123 hours.
Contact service Engineer.