Visual Display - Ransomes MP655 Quick Start Manual

VISUAL DISPLAY

START UP SCREEN
When the ignition key is turned to the start
position, this screen is shown.
The hour meter will show total hours of
engine operation.
WARNING/SERVICE SCREEN
If incorrectly used this machine can cause
severe injury. Those who use and maintain
this machine should be trained in its proper
use, warned of its dangers and should read
the entire operators manual before attempting
to set up, operate, adjust or service the
After the start up screen, the warning screen
is shown.
If the machine is within 5 hours of the next
service interval, a warning is shown. An
operator input is needed to continue to the
main screen for operation. Otherwise the
main run screen appears. If a fault condition
has occurred during the previous start, a pop
up screen over the top of the warning screen
shows the fault. The operator must confirm
the fault, to continue to the main screen.
WARNING
machine.
QUICK START GUIDE
FIRST SCREEN
This screen shows the cutter switch in the
OFF position, the transport lock engaged,
the TST is in operation and speed mode.
By pressing the MODE button the transmission
mode can be changed between Automatic,
Manual and Creep.
Note. The TST (Tilt Safety Technology) is an
active safety device to stop the machine
being used in dangerous conditions.
ENGINE START
When the ignition key is turned to the start
position, this screen is shown.
If the parking brake is applied, the cutting
unit switch is in the OFF position and the foot
pedal is in the Neutral position and when the
operator is in the seat, the engine will start.
This screen shows the fuel bar graph on the
left side. The colour changes from green to
red as the fuel level decreases. The engine
temperature gauge is on the right side. The
colour changes from green to red as the
temperature increases.
MODE
en-13