Warning Slope Angle - Stop Cut; Warning Oil Pressure Fault; Warning Engine Overheat - Ransomes MT383 Safety, Operation & Maintenance Manual/Parts List

Table of Contents

6.6.4 WARNING SLOPE ANGLE – STOP CUT__________________________________

If the slope angle continues to increase the screen will display this

warning which indicates that the cutters have been switched off and

disabled. An audible warning will sound continuously for 4 seconds

at 4 second intervals, and the red LEDs will flash continuously for 4

seconds at 4 second intervals. This will continue until the machine

has been driven to an area with a shallower slope angle. The

warning screen and the audible alarm will self-clear as the vehicle

angle decreases (i.e. the operator does not need to press Button 4

to clear it). The angle at which this warning occurs varies with

machine configuration as follows.

The angle at which this warning occurs varies with machine

configuration as follows:

• MT383 with ROPS – 24°

• MT383 with Cab – 21°

When this screen is shown, the engine oil pressure has decreased below

the normal level. If this happens during operation, or does not go off when

the engine is run at more than 1000 rpm. Stop the engine and check the

oil level. Top up if necessary.

If the fault persists, do not use the machine at all and contact your local

Ransomes Jacobsen dealer.

When this screen is shown, the engine

temperature has risen above the normal

levels.

If not actioned the engine power will be

derated until fault is resolved.

Park the machine in a safe area

disengage cutting units, set engine to idle

to allow engine temperature to decrease

prior to switching off the engine.

Clean the radiator and screens of all

grass and debris.

CONTROLS 6

1234

1/1

123.4 Hours

en-49

Table of Contents