Nortel Communication Server 1000 Fundamentals page 63

11 Measure the ground resistance between the ground lug at the
bottom of the NTAK11BA cabinet and the ground prong on the
cabinet power cord. It should measure 0 ohms. If the resistance
is greater than 0 ohms, check the ground terminal on the power
supply power connector for continuity to the cabinet.
12 Disconnect the power cord from the wall outlet for the AC system
or the DC power source for the DC system and reconnect the 6
AWG ground wire to the cabinet ground lug.
13 Reconnect the NTAK98AA supply power cord to the AC power
outlet for an AC system or to the DC source for a DC system.
This completes the cabinet installation and system ground test. You can
now install the plug-in cards.
Installing cards into the remote cabinet
The following steps show you how and where to install the NT5D67
RMI and other cards in the remote cabinet. This document provides
step-by-step card installation, which should be followed when additional
cards are installed or defective cards are replaced.
WARNING
DO NOT ALTER JUMPER SETTINGS!
The jumpers at J3 determine board-type and should never be
removed or changed. Refer to
MCR circuit packs." (page 55)
jumpers.
Procedure 5
Installing cards into the remote cabinet
Step Action
1 Set the DIP switches on the NT5D67 RMI to specify the distance
to the first repeater, framing mode, MMI terminal baud, and the
system terminal settings. See
(page 65). (All defaults are OFF.) The DIP switch setting will
depend on the physical system configuration.
2 Pull the RMI locking devices away from the faceplate. Holding
the card by these locking devices, insert it into the card guides in
the card slot marked CPU, which is located in slot 0.
3 Slide the card into the module until it engages the backplane
connector.
4 Push the locking device levers toward the faceplate to insert the
card connector into the backplane connector and lock the card in
place.
Nortel Communication Server 1000
Mini-Carrier Remote Fundamentals
NN43001-557 04.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
System installation 63
--End--
Figure 11 "Jumper settings on
for the proper settings for these
Table 16 "RMI SW3 functions"