Nortel Communication Server 1000 Fundamentals page 56

56 Installation and configuration
Procedure 1
Installing the LMI
Step
1
2
3
4
5
Table 9 "LMI SW2 at U23 functions" (page 56)
DIP switch 2 (SW2) at each position:
Table 9
LMI SW2 at U23 functions
Position
1-5
6
7
8
Each position's default is OFF. All boards are shipped configured for a
single-board system, not daisy chained, where the board is physically
connected to both the MMI and SDI. All boards must be specifically
addressed to be a part of a daisy chain.
MMI end and SDI end
For daisy chains with more than two LMIs, all cards not on the ends must
have DIP Switch 2 (SW2), positions 7 and 8, ON. In cases in which there
are three LMIs in the daisy chain, LMI 1 and LMI 3 are end cards, each of
Action
Set the DIP switches to specify the distance to the CSU, the MMI
terminal baud, and the daisy-chain address. The DIP switch
settings outlined in
56) and Table 10 "LMI SW3 at U51 functions" (page 57)
depend on the physical system configuration.
Pull the LMI locking devices away from the faceplate. Holding
the card by these locking devices, insert it into the card guides
of the selected line card slots.
Slide the card into the module until it engages in the backplane
connector.
Carefully push the locking device levers toward the faceplate to
insert the card connector into the backplane connector and lock
the card in place.
The card LED should blink three times and then stay on until
enabled by software. When enabled by software, the card LED
turns off permanently, as long as the card is operational.
Usage
Binary daisy chain address
OFF (not used)
OFF = MMI End, ON = Not MMI end
OFF = SDI End, ON = Not SDI end
Nortel Communication Server 1000
Mini-Carrier Remote Fundamentals
NN43001-557 04.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
Table 9 "LMI SW2 at U23 functions" (page
--End--
shows the functions of LMI
will