Nortel Communication Server 1000 Fundamentals page 61

Table 14
LMX DIP SW2 function: LMX address
Position (1 = ON, 0 = OFF)
1 2
0 0
1 0
0 1
Install the LMX into two consecutive line card slots in the same shelf or
cabinet as the LMI.
WARNING
DO NOT ALTER JUMPER SETTINGS!
The jumpers at J3 determine board-type and should never be
removed or changed. Refer to
MCR circuit packs." (page 55)
jumpers.
Procedure 3
Connecting the LMI/LMX cable assembly
Step Action
1 Connect Plug 1 of the LMI/LMX cable assembly (NT5D86) to the
50-pin Amphenol connector for the second of two slots for the
LMI (see Figure 6 "LMI/LMX Multi-I/O cable assembly (NT5D86)"
(page 22)).
2 Connect Plug 2 of the LMI/LMX cable assembly to the 50-pin
Amphenol connector for the second of the two line card slots
occupied by LMX 1.
Note: The 50-pin Amphenol connector for the first of the two
line card slots is not used.
3 In the same way, connect Plug 3 of the NT5D86 LMI/LMX cable
assembly to the 50-pin Amphenol connector for the second of
the two line card slots occupied by LMX 2.
4 Finally, connect Plug 4 of the NT5D86 LMI/LMX cable assembly
to the 50-pin Amphenol connector for the second of the two line
card slots occupied by LMX 3. (See
single Local Mini-carrier Interface card (LMI)" (page
Nortel Communication Server 1000
Mini-Carrier Remote Fundamentals
NN43001-557 04.01 4 June 2010
Copyright © 2003-2010 Nortel Networks. All Rights Reserved.
LMX Number
LMX 0
LMX 1
LMX 2
Figure 11 "Jumper settings on
for the proper settings for these
Figure 8 "Cabling for a
--End--
System installation 61
41).)