Mercedes-Benz CLK-Class Owner's Manual page 370

If you have obtained a pressure of
1.8 bar, press the switch on the elec-
tric air pump to 0.
The electric air pump is switched off.
Disconnect the electric air pump.
Pull away immediately.
This allows the TIREFIT sealant to dis-
tribute throughout the tyre.
Stop after about ten minutes and
check the tyre pressure with the elec-
tric air pump.
G
Risk of accident
If the pressure has fallen below 1.3 bar, the
tyre is too badly damaged.
Do not drive any further. Consult a qualified
specialist workshop which has the neces-
sary specialist knowledge and tools to carry
out the work required. Mercedes-Benz rec-
ommends that you use a Mercedes-Benz
Service Centre for this purpose. In particu-
lar, work relevant to safety or on safety-
related systems must be carried out at a
qualified specialist workshop.
If the tyre pressure is at least 1.3 bar,
correct it (see fuel filler flap for values).
To increase the tyre pressure:
switch on the electric air pump
To decrease the tyre pressure:
open the pressure release screw on
pressure gauge 9
Practical advice
Drive to the nearest workshop and
have the tyre replaced.
Have the TIREFIT kit replaced as soon
as possible at a qualified specialist
workshop, e.g. a Mercedes-Benz Serv-
ice Centre.
G
Risk of accident
Do not exceed the maximum speed of
80 km/h.
The "max. 80 km/h" sticker must be affixed
within the driver's field of vision.
The vehicle's handling characteristics may
be affected.
H
Environmental note
Have the TIREFIT kit disposed of profession-
ally, e.g. at a Mercedes-Benz Service Centre.
Have the TIREFIT kit replaced every
four years at a qualified specialist
workshop, e.g. a Mercedes-Benz Serv-
ice Centre.
Flat tyre
367