Mercedes-Benz CLK-Class Owner's Manual page 369

Practical advice
Flat tyre
P40.10-3328-31
7 Valve
8 Switch
9 Pressure gauge with pressure release
screw
a Filler hose
Unscrew and remove the valve cap of
the flat tyre's valve.
Make sure that the pressure release
screw on pressure gauge 9 is closed.
Screw filler hose a onto valve 7.
366
Insert connector 4 into:
the cigarette lighter socket
( page 230)
or
a 12V socket* in your vehicle
( page 231)
Turn the key to position 1 in the igni-
tion lock ( page 23).
Press electric air pump switch 8 to I.
The electric air pump is switched on.
The tyre is pumped up. After five min-
utes, a tyre pressure of at least 1.8 bar
must be obtained.
!
Do not run the electric air pump for longer
than six minutes without a break, otherwise it
may overheat.
The air pump can be used again once it has
cooled down.
If this tyre pressure is not obtained:
Switch off and disconnect the elec-
tric air pump, and drive the vehicle
back and forth approximately 10 m.
This distributes the TIREFIT sealant
more evenly.
Remove the sealant bottle from the
electric pump.
Pump up the tyre again.
G
Risk of accident
If a pressure of 1.8 bar is not obtained with-
in five minutes, the tyre is too badly dam-
aged.
Do not drive any further. Consult a qualified
specialist workshop which has the neces-
sary specialist knowledge and tools to carry
out the work required. Mercedes-Benz rec-
ommends that you use a Mercedes-Benz
Service Centre for this purpose. In particu-
lar, work relevant to safety or on safety-
related systems must be carried out at a
qualified specialist workshop.