Factory Defaults; Boot Option - Extreme Networks Summit Summit1 Installation And User Manual

To save the conÞguration, use the following command:
save {config} {primary | secondary}
To use the conÞguration, use the following command:
use config {primary | secondary}
The conÞguration takes effect on the next reboot.
R
ETURNING TO
To return the Switch conÞguration to factory defaults, enter the following command:
unconfig switch
This command resets the entire conÞguration, with the exception of user accounts and
passwords that have been conÞgured.
To reset all parameters, enter the following command:
unconfig switch all
B
OOT
Table 11-1
Table 11-1: Boot Option Commands
Command
download config <ipaddress> <filename>
download image <ipaddress> <filename>
{primary | secondary}
save {config} {primary | secondary}
S S I
UMMIT WITCH NSTALLATION AND
F
ACTORY
O C
PTION OMMANDS
lists the commands associated with Summit boot options.
U G
SER UIDE
D
EFAULTS
Description
Downloads a previously saved ASCII
configuration file from a specific IP host. You
must specify the IP address of the host and
the configuration filename.
Downloads a new image from a TFTP server.
You must specify the IP address of the TFTP
server and the image filename.
Saves the current configuration of the Switch
to NVRAM. You can specify the primary or
secondary configuration area. If not specified,
the configuration is saved to the configuration
area currently in use.
B O C
OOT PTION OMMANDS
11-3