Table of Contents
Advertisement
HWC_GSG_APConfiguration.fm
Altitude AP's configuration
Configuring VLAN tags for Altitude APs
92
7.6.1 Resetting the Altitude AP to its factory default
settings
You can reset the Altitude AP to its factory default settings if the Altitude APs
incorrectly configured.
The Altitude AP boot-up sequence includes a random delay interval, followed by
a vulnerable time interval. During the vulnerable time interval (2 seconds), the
LEDs flash in a particular sequence to indicate that the Summit WM Switch is in
the vulnerable time interval. For more information, see
LED states", on page
93.
If you power up the Altitude AP and interrupt the power during the vulnerable time
interval three consecutive times, the fourth time the Altitude AP reboots, it will
restore its factory defaults including the user password and the default IP settings.
To reset the Altitude AP to its factory default settings:
1. Reboot the Altitude AP.
2. Depower and repower the Altitude AP during the vulnerable time interval.
3. Repeat Step 2 two more times.
When the Altitude AP reboots for the fourth time, after having its power supply
interrupted three consecutive times, it restores its factory default settings. The
Altitude AP then reboots again to put the default settings into effect.
Reset button (Hardware)
You can also reset the Altitude AP to its factory default settings by pressing and
holding the Reset button on the Altitude AP for approximately five seconds. Not
all models of the Altitude APs have the Reset button
The following figure illustrates the location of the Reset button on the Altitude
APs.
AC/DC Power
Supply
Section 7.7, "Altitude AP's
Ethernet
Reset
Port
Button
120385-00 Rev 01, March 2007
Summit WM, Getting Started Guide
Advertisement
Table of Contents
