Extreme Networks Summit Summit1 Installation And User Manual page 58

C
OMMANDS
Table 4-9: FDB Commands (continued)
Command
create fdbentry <mac_address> vlan <name>
<portlist>
delete fdbentry <mac_address> vlan <name>
config fdb agingtime <number>
P C
ORT OMMANDS
Table 4-10 describes port commands.
Table 4-10: Port Commands
Command
show port <portlist> config
show port <portlist> stats
show port <portlist> errors
show port <portlist> collisions
show port <portlist> packet
config port <portlist> auto on
4-14
Description
Creates a permanent FDB entry. Specify the
following:
mac_address — Device MAC address,
using colon-separated bytes.
name — VLAN associated with MAC
address.
portlist — Port number associated with
MAC address.
If more than one port number is associated
with a permanent MAC entry, packets are
multicast to the multiple destinations.
Deletes a permanent FDB entry.
Configures the FDB aging time. The range is
15 through 1,000,000 seconds. The default
value is 1,800 seconds. A value of 0 indicates
that the entry should never be aged out.
Description
Displays state, link status, speed, and
autonegotiation setting for each port.
Displays port information including physical
layer configuration and statistics.
Displays error information for one or more
ports.
Displays real-time collision statistics.
Displays a histogram of packet statistics for
one or more ports.
enables autonegotiation for the particular port
type: 802.3u for 10/100 Mbps ports or 802.3z
for Gigabit Ethernet ports.
S S I
UMMIT WITCH NSTALLATION AND
U G
SER UIDE