Extreme Networks Summit Summit1 Installation And User Manual page 116

IP U R
NICAST OUTING
Table 9-3: RIP Configuration Commands (continued)
Command
config rip rxmode [none | v1only | v2only |
any] {vlan <name> | all}
config rip txmode [none | v1only | v1comp |
v2only] {vlan <name> | all}
config rip updatetime {<delay>}
disable rip
disable rip aggregation
disable rip splithorizon
disable rip poisonreverse
disable rip triggerupdate
disable rip exportstatic
unconfig rip {vlan <name> | all}
9-8
Description
Changes the RIP receive mode for one or
more VLANs. Specify:
none — Drop all received RIP packets.
v1only — Accept only RIP version 1 format
packets.
v2only — Accept only RIP version 2 format
packets.
any — Accept both version 1 and version 2
packets.
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is any.
Changes the RIP transmission mode for one or
more VLANs. Specify:
none — Do not transmit any packets on this
interface.
v1only — Transmit RIP version 1 format
packets to the broadcast address.
v1comp — Transmit version 2 format
packets to the broadcast address.
v2only — Transmit version 2 format
packets to the RIP multicast address
If no VLAN is specified, the setting is applied
to all VLANs. The default setting is v2only.
Changes the periodic RIP update timer. The
default setting is 30 seconds.
Disables RIP.
Disables the RIP aggregation of subnet
information on a RIP version 2 interface.
Disables split horizon.
Disables poison reverse.
Disables triggered updates
Disables the filtering of static routes.
Resets all RIP parameters to the default VLAN.
Does not change the enable/disable state of
the RIP settings.
S S I
UMMIT WITCH NSTALLATION AND
U G
SER UIDE