Table of Contents
Advertisement
Step 5.
Disconnect the retimer cables from system board.
a.
Disconnect the eight retimer signal cables from the system board, and remove them from
the cable clips.
b.
Disconnect the retimer power cable from the system board, and remove it from the cable
clips.
Figure 256. Disconnecting the retimer cables
Step 6.
Rotate down the SXM GPU board handle and clips so that they are away from the retimer
assembly.
Figure 257. Closing the GPU-L2A assembly clips and handle
ThinkSystem SR670 V2 Maintenance Manual
320
Advertisement
Table of Contents
