Table of Contents
Advertisement
Figure 246. Rotate the L2A clockwise
c. Turn the L2A upside up.
Hold the right end of the radiator which is attached with the tubes, and hold the cold plate
assembly lifting handle.
Rotate the L2A clockwise so that the upper side of the radiator and cold plate assembly lifting
handle are facing up.
Attention: To prevent cold plate assembly thermal grease from contacting the flat surface below, lift
up the cold plate assembly before installing it onto the SXM GPU board.
Figure 247. Turning the L2A upside up
d. Reinstall the L2A. See "Install the Lenovo Neptune(TM) liquid-to-air (L2A) hybrid cooling module" on
page 289.
2. Reinstall the retimer assembly. See "Install the retimer assembly" on page 322.
.
Chapter 4
Hardware replacement procedures
311
Advertisement
Table of Contents
