Lenovo ThinkSystem SR670 V2 Maintenance Manual page 216

Figure 147. PHM components
Heat sink
1
Processor identification label
2
Heat sink triangular mark
3
Nut and wire bail retainer
4
Torx T30 nut
5
Anti-tilt wire bail
6
Processor carrier
7
Clips to secure carrier to heat sink
8
Notes:
• The heat sink, processor, and processor carrier for your system might be different from those shown in the
illustrations.
• PHMs are keyed for the socket where they can be installed and for their orientation in the socket.
• See https://static.lenovo.com/us/en/serverproven/index.shtml
server. All processors on the system board must have the same speed, number of cores, and frequency.
• Before you install a new PHM or replacement processor, update your system firmware to the latest level.
See "Update the firmware" in the ThinkSystem SR670 V2 Setup Guide.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku:
https://list.youku.com/albumlist/show/id_59636529
ThinkSystem SR670 V2 Maintenance Manual
208
Clips to secure processor in carrier
9
Carrier triangular mark
10
Processor ejector handle
11
Processor heat spreader
12
Thermal grease
13
Processor contacts
14
Processor triangular mark
15
for a list of processors supported for your