Table of Contents
Advertisement
b.
Lift up the SXM GPU power distribution board out of the chassis.
Note: Remove the screws with a torque screwdriver sets to the proper torque. For reference,
the torque required for the screws to fully tighten/removal is 0.6±0.06 newton-meter, 5±0.5
pound-inch.
Torque screwdriver type list
PH 1 head screwdriver
Figure 250. Removing the SXM GPU power distribution board
After you finish
• Install a replacement unit. See "Install the SXM GPU power distribution board" on page 314.
• To replace the power distribution board, see "Power distribution board replacement" on page 194.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the SXM GPU power distribution board
Follow instructions in this section to install the SXM GPU power distribution board.
About this task
ThinkSystem SR670 V2 Maintenance Manual
314
Screw Type
Phillips #1 head screw
Advertisement
Table of Contents
