Table of Contents
Advertisement
Figure 169. Removing the 2.5-inch drive cage assembly
Remove the 3.5-inch drive cage assembly:
a.
Loosen the two thumbscrews that secure the 3.5-inch drive cage assembly to the chassis.
b.
Slide the drive cage assembly out of the chassis.
Figure 170. Removing the 3.5-inch drive cage assembly
After you finish
• Install a replacement unit. See "Install the 2.5-/3.5-inch drive cage assembly" on page 237.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the 2.5-/3.5-inch drive cage assembly
Follow instructions in this section to install the 2.5-inch or 3.5-inch drive cage assembly.
About this task
Attention:
• Read "Installation Guidelines" on page 121 and "Safety inspection checklist" on page 122 to ensure that
you work safely.
• Touch the static-protective package that contains the drive to any unpainted metal surface on the
solution; then, remove the drive from the package and place it on a static-protective surface.
.
Chapter 4
Hardware replacement procedures
237
Advertisement
Table of Contents
