Table of Contents
Advertisement
Step 5.
Install the memory module into the slot.
a.
Carefully use a common tool to press the retaining clips.
b.
Push the retaining clips outward on each end of the memory module slot.
c.
Align the memory module with the slot, and gently place the memory module on the slot
with both hands. Firmly press both ends of the memory module straight down into the slot until
the retaining clips snap into the locked position.
Attention:
• To avoid breaking the retaining clips or damaging the memory module slots, open and close
the clips gently.
• If there is a gap between the memory module and the retaining clips, the memory module
has not been correctly inserted. In this case, open the retaining clips, remove the memory
module, and then reinsert it.
Figure 118. Memory module installation
Step 6.
Align the cable guide with the guide pins; then, attach the cable guide to the chassis, and slide it
down to secure it in place.
ThinkSystem SR670 V2 Maintenance Manual
178
Advertisement
Table of Contents
