Table of Contents
Advertisement
Figure 210. Removing the front I/O expansion board module
After you finish
• Install a replacement unit. See "Install the front I/O expansion board module" on page 277.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the front I/O expansion board module
Follow instructions in this section to install the front I/O expansion board module.
About this task
Attention:
• Read "Installation Guidelines" on page 121 and "Safety inspection checklist" on page 122 to ensure that
you work safely.
• Touch the static-protective package that contains the drive to any unpainted metal surface on the server;
then, remove the drive from the package and place it on a static-protective surface.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku:
https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1.
Install the front I/O expansion board module.
a.
Push the release latch on the cross bar.
b.
Hold the module at an angle, and insert the two guide pins on system board into the guide
holes on the module.
c.
Lower the module into the chassis.
.
Chapter 4
Hardware replacement procedures
277
Advertisement
Table of Contents
