Table of Contents
Advertisement
Step 2.
Remove the PHM from the system board.
a.
Fully loosen the Torx T30 nuts on the PHM in the removal sequence shown on the heat sink
label.
b.
Rotate the anti-tilt wire bails on the heat sink inward.
c.
Carefully lift the PHM from the processor socket. If the PHM cannot be fully lifted out of the
socket, further loosen the Torx T30 nuts and try lifting the PHM again.
d.
Place the PHM upside down with the processor-contact side up.
Notes:
• Do not touch the contacts on the processor.
• Keep the processor socket clean from any object to prevent possible damages.
Figure 143. PHM removal
After you finish
• Empty processor socket must always contain a socket cover and a filler before the server is powered on.
• If you are removing the PHM as part of a system board replacement, set the PHM aside.
• If you are reusing the processor or heat sink, separate the processor from its carrier. See "Separate the
processor from carrier and heat sink" on page 204
• If you are instructed to return the defective component, package the part to prevent any shipping damage.
Reuse the packaging the new part arrived in and follow all packaging instructions.
.
Chapter 4
Hardware replacement procedures
203
Advertisement
Table of Contents
