Lenovo ThinkSystem SR670 V2 Maintenance Manual page 183

Step 3. Remove the memory module from the slot.
a. Carefully use a common tool to press the retaining clips.
b. Push the retaining clips outward on each end of the memory module slot.
c. Grasp the memory module at both ends and carefully lift it out of the slot.
Attention:
• Remove or install memory modules for one processor at a time.
• To avoid breaking the retaining clips or damaging the memory module slots, handle the clips
gently.
Notes:
• The retaining clips for adjacent memory module slots of processor 1 and processor 2 can not be
open at the same time. Remove or install the memory module for each processor one at a time
and close the retaining clips after removing a memory module.
• If necessary, due to space constraints, you can use a pointed tool to open the retaining clips.
Place the tip of the tool in the recess on the top of the retaining clip; then, carefully rotate the
retaining clip away from the memory module slot. Make sure you use firm and solid pointed tool
to open the latch. Do not use pencils or other fragile tools.
Figure 116. Memory module removal
After you finish
1. A memory module slot must be installed with a memory module or a memory module filler. See "Install a
memory module" on page 175.
2. Change and save the new configuration information by using the Setup utility. When you turn on the
server, a message indicates that the memory configuration has changed. Start the Setup utility and
select Save Setting to save changes. (see the ThinkSystem SR670 V2 Setup Guide for more
information)
3. If you are instructed to return the component or optional device, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
Install a memory module
Follow instructions in this section to install a memory module.
About this task
.
Chapter 4 Hardware replacement procedures
175