Lenovo ThinkSystem SR670 V2 Maintenance Manual page 253

After you finish
• Install a replacement unit. See "Install the EDSFF drive backplane" on page 245.
• If you are instructed to return the component or optional device, follow all packaging instructions, and use
any packaging materials for shipping that are supplied to you.
Install the EDSFF drive backplane
Follow instructions in this section to install the EDSFF drive backplane.
About this task
Attention:
• Read "Installation Guidelines" on page 121 and "Safety inspection checklist" on page 122 to ensure that
you work safely.
• Touch the static-protective package that contains the component to any unpainted metal surface on the
server; then, remove it from the package and place it on a static-protective surface.
Watch the procedure. A video of the installation and removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-BXei6L6c05osQVLt4w5XYx
• Youku:
https://list.youku.com/albumlist/show/id_59636529
Procedure
Step 1. Fasten the two screws to secure the drive backplane to the drive cage.
Figure 181. Installing the EDSFF drive backplane
After you finish
1. Reinstall the EDSFF drive cage assembly. See "Install the EDSFF drive cage assembly" on page 247.
2. Reconnect the power and signal cables to the EDSFF drive backplane.
3. Reinstall the EDSFF hot-swap drive or drive bay filler (if any). See "Install an EDSFF hot-swap drive" on
page 241.
4. Complete the parts replacement. See "Complete the parts replacement" on page 328.
.
Chapter 4 Hardware replacement procedures
245