Table of Contents
Advertisement
Step 6.
With a PH 1 head screwdriver, unfasten the seven Philip #1 screws that secure the radiator to the
GPU tray. Remove the screws with a torque screwdriver set to the proper torque. For reference, the
torque required for the screws to fully tighten is 0.3±0.03 newton-meter, 2.7±0.27 pound-inch.
Figure 218. Unfastening the screws on the radiator
Radiator
1
Cold plate assembly
2
.
Chapter 4
Hardware replacement procedures
285
Advertisement
Table of Contents
