I
1-4
nstallatIon
SERIAL PLATE LOCATION
The serial plate is located on the back of the
unit near refrigeration system .
REFRIGERATION UNIT ACCESS
Remove side panel screws to gain access to
the condensing unit . Check inside this panel
to make sure all electrical wiring is secured,
and that there is no damage to the unit from
shipment or placement . Confirm there are no
refrigerant leaks during startup of the case(s) .
P/N 3116321_A
SEALING MERCHANDISER TO FLOOR
If required by local sanitary codes, or if the
customer desires, merchandisers may be sealed
to the floor . The size needed will depend on
how much variation there is in the floor, from
one end of the merchandiser to the other .
Sealing of the lower front and rear panels
on self contained models may hamper their
removal for servicing or maintenance of the
condensing unit .
NOTE: Do not allow trim to cover any intake
or discharge grilles located in the lower front
panel .
Do not climb on or get inside the
equipment. Materials in the case could
break and presents a risk of physical
injury and damage to the equipment.
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
Access
Panel