Table of Contents
Advertisement
P/N 3116321_A
Move the merchandiser as close as possible to
its permanent location and remove all packaging .
Check for damage . Remove all separately
packed accessories . Improper handling may
cause damage to the merchandiser when
unloading .
To avoid damage:
1 . Do not drag the merchandiser out of the
trailer . Use a Johnson bar (mule) . Use a
forklift or dolly to remove the merchandiser
from the trailer .
2 . Use caution when moving case to
setup location . Use care to not damage
refrigeration system .
SHIPPING SKID
Each merchandiser is shipped on a skid to
protect the merchandiser's base, and to make
positioning the case easier .
Remove any braces and/or skids attached
(blanket wrapped merchandiser may have
skids) .
DO NOT LAY MERCHANDISER OVER ON
THE FLOOR TO REMOVE SKID .
Once the skid is removed, the merchandiser
must be lifted —NOT PUSHED— to reposition .
To remove the skid, remove screws attaching
skid to the merchandiser . Check floor where
cases are to be set to see if it is a level area .
Determine the highest part of the floor .
Do NOT remove shipping
skid until the merchandiser is
positioned for installation.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
MERCHANDISER LEVELING
B
e sure to position merchandisers
. Level the merchandiser by all four
properly
corners . Merchandiser(s) must be installed
level to ensure proper operation of the
refrigeration system and to ensure proper
drainage of defrost water .
ADJUSTABLE MOUNTING FEET
Leveling mounting feet are provided with
the case . A wood block can be used to raise
the case in order to lower the feet . Use a 4-ft
level around the case rails, and raise the feet
accordingly to ensure the case is level at all
four corners .
Use Pry Bar and Wood Block to Raise Case
so that the Feet can be unscrewed.
1
Island Self Contained R-290
1-3
2
Advertisement
Table of Contents
