Table of Contents
Advertisement
P/N 3116321_A
MERCHANDISER ELECTRICAL DATA
Refer to the technical data sheets and case
serial plate for electrical information .
FIELD WIRING
Field wiring must be sized for component
amperes stamped on the serial plate . Actual
ampere draw may be less than specified .
ALWAYS CHECK THE SERIAL PLATE FOR
COMPONENT AMPERES
ELECTRICAL CONNECTIONS
All wiring must be in compliance with NEC
and local codes .
ELECTRICAL OUTLET:
Before the merchandiser is connected to any
wall circuit, use a voltmeter to check that the
outlet is at 100% of the rated voltage . The wall
circuit must be dedicated for the merchandiser .
Failure to do so voids the warranty . Do not
use an extension cord . Never plug in more
than one merchandiser per electrical circuit .
• Always use a dedicated circuit with the
amperage stated on the unit .
• Plug into an outlet designed for the plug .
• Do not overload the circuit
• Do not use long or thin extension cords .
Never use adapters .
• If in doubt, call an electrician .
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
ELECTRICAL / REFRIGERATION
NEMA 5-15P
Self-contained models have factory-installed
power cords attached at the electrical box . If
the power cord is damaged, it must be replaced
by personnel qualified for this task to prevent
hazardous situations .
Merchandiser must be grounded.
Do not remove the power sup
Risk of Electric Shock. If cord or plug
becomes damaged, replace only with
a cord and plug of the same type.
REFRIGERATION
Each model is equipped with its own
condensing unit and control panel located
underneath the display area behind the vented
panels . The correct type of refrigerant will be
stamped on each merchandiser's serial plate .
The merchandiser refrigeration piping is leak
tested .
Island Self Contained R-290
Plug
ply cord
ground.
2-1
Advertisement
Table of Contents
