Connecting Power - Enterasys Matrix E1 1G587-09 Installation Manual

Figure 3-11 Fastening the Device to the Rack
À
Á
➀
Rails of 19-inch rack
3.7.4

Connecting Power

NOTE: The two power supplies in the device have automatic voltage sensing that
allows connection to power sources ranging from 100–125 Vac, 2.5 A or 200–240 Vac,
1.25 A, 50/60 Hz.
To connect the device to the power sources, refer to
1. Plug a power cord
capabilities, each power cord must be plugged into a separate dedicated ac outlet
2. Plug the other end of each power cord
Figure 3-12.
NOTE: To take advantage of the load sharing and redundancy capabilities, each power
cord must be plugged into a separate dedicated ac outlet.
➀
into each switch ac power receptacle
Á
➁
Mounting screws (supplied by user)
Figure 3-12
➀
into a dedicated grounded ac outlet
À
and proceed as follows:
➁
. To take advantage of redundancy
➂
Hardware Installation
Installation
➂
.
as shown in
3-19