Enterasys Matrix E1 1G587-09 Installation Manual page 43

To prepare and install a Mini-GBIC into the 1G-2MGBIC, proceed as follows:
Preparation
Before installing the Mini-GBIC, proceed as follows:
1. Attach the antistatic wrist strap (refer to the instructions in the antistatic wrist strap package)
before removing the Mini-GBIC from the antistatic packaging.
2. Remove the Mini-GBIC from the packaging.
3. If there is a protective dust cover (see
at this time.
Installation
To install a Mini-GBIC with an MT-RJ connection, refer to
LC connection, refer to
NOTE: If the Mini-GBIC is one with an RJ45 connector (not shown), the installation
procedure is the same as described below. However, that type Mini-GBIC has a wire
handle to release it.
To install a Mini-GBIC, refer to
1. Hold the Mini-GBIC
1G-2MGBIC port slot
2. Carefully align the Mini-GBIC
3. Push the Mini-GBIC
Figure
Figure 3-7, and proceed as follows:
Figure 3-6
➀
with its top side
➃
as shown in Figure
➀
with the 1G-2MGBIC port slot
➀
into the port slot
➄
3-6, ) on the Mini-GBIC port, do not remove it
Figure
and proceed as follows:
➁
facing up and its 7-pin edge connector
3-6.
➃
until the Mini-GBIC "clicks" and locks into place.
3-6, or for a Mini-GBIC with an
➂
➃
.
Hardware Installation
Preparation
facing the
3-13