Simm Replacement Procedure; Locating Simms; B.4.1 Locating Simms; Removing The Dram Simm - Enterasys Matrix E1 1G587-09 Installation Manual

SIMM Replacement Procedure

B.4 SIMM REPLACEMENT PROCEDURE
In the event that the DRAM Single In-line Memory Module (SIMM) needs to be replaced, this
section explains how to access and locate the SIMM. If you have questions concerning the
replacement of the SIMM, refer to
B.4.1

Locating SIMMs

Figure B-3 shows the location of the DRAM SIMM connector
B.4.2

Removing the DRAM SIMM

To remove the existing DRAM SIMM, proceed as follows:
1. To gain access to the SIMM, remove the top cover of the device as described back in
2. Locate the DRAM SIMM
Figure B-3 SIMM Connector Location (Chassis, Top View)
➀
DRAM SIMM connector
3. Push the release tabs
simultaneously lift the DRAM SIMM enough to release it from the connector
B-6 Optional Installations and Mode Switch Bank Settings
Section 1.4
➀
connector on the main PC board. See
➀
away from the DRAM SIMM
for details on how to contact Enterasys Networks.
➀
.
➁
, as shown in
Section
Figure B-3.
À
Figure B-4 and
➂
.
B.2.