Enterasys Matrix E1 1G587-09 Installation Manual page 87

2. If the 1G58x-09 is rack mounted, remove it from the rack (refer to
3. Use a Phillips screwdriver to remove the 12 screws
(see Figure B-1).
Figure B-1 Removing the Chassis Cover
Â
➀
Cover screws (12)
4. Remove the top cover
switches, proceed to
To reinstall the chassis cover, perform the removal procedures in reverse.
À
Á
➁
Top cover
➁
by lifting it straight up and off the chassis
Section B.3. If you are replacing a SIMM, proceed to
Optional Installations and Mode Switch Bank Settings
Removing the Chassis Cover
Chapter
➀
attaching the top cover
➂
1G58x-09 device (1G582-09 is shown)
➂
. If you are setting the mode
3).
➁ ➂
to the chassis
Section B.4.
B-3