3.2.12
Adjustment of Scale Solenoid SOL3
NOTE
Requirement
The exposed end of the Stopper Lever is positioned within approximately
8.7 ± 0.2 mm in length.
1. Remove the Turnover/Exit Unit Assy and place it on a table upside down.
2. Loosen two screws.
3. Move the Solenoid up and down so that the exposed end of the Stopper Lever
is within the specified length.
4. Tighten the two screws.
Rev. 1.0/05.99
D-19
AFR-12/AF-5